Good point. Thanks to both of you for your help.
Craig
Quoting Josh Luthman <[EMAIL PROTECTED]>:
With that being the case take note if you have to replace the board
and do a backup/restore!
On 11/7/08, Butch Evans <[EMAIL PROTECTED]> wrote:
On Fri, 7 Nov 2008, Craig Baird wrote:
I've got something weird going on. I just configured an RB532 with
the RB564 daugterboard. Here's what I'm seeing:
This is very confusing when trying to figure out which port to
physically plug various cables into. I've tried resetting the
config, but it didn't change anything. Any suggestions on what I
can do to get the port ordering straightened back out?
This is a common issue. The only "fix" is to rename the interfaces.
It is a problem that I know MT has been told about, but they did
not, could not or would not (take your pick) change the behaviour.
--
********************************************************************
* Butch Evans * Professional Network Consultation*
* http://www.butchevans.com/ * Network Engineering *
* http://www.wispa.org/ * WISPA Board Member *
* http://blog.butchevans.com/ * Wired or Wireless Networks *
********************************************************************
_______________________________________________
Mikrotik mailing list
[email protected]
http://www.butchevans.com/mailman/listinfo/mikrotik
--
Sent from my mobile device
Josh Luthman
Office: 937-552-2340
Direct: 937-552-2343
1100 Wayne St
Suite 1337
Troy, OH 45373
Those who don't understand UNIX are condemned to reinvent it, poorly.
--- Henry Spencer
_______________________________________________
Mikrotik mailing list
[email protected]
http://www.butchevans.com/mailman/listinfo/mikrotik
