On Saturday, December 31, 2011 10:58 CET, "Sebastian Reitenbach" <sebas...@l00-bugdead-prods.de> wrote: > Hi, > > I have a Soekris box equipped with an 8 port serial card I use to manage all > my hardware using cu. > Right now I'm running 4.6 on it, and thought, its time to upgrade, so > installed -current from today ;) > Luckily I did the new installation on a separate CF card, to easily go back. > > When I now try to a serial console using a port tty04 or above, then I only > get garbage. For example I call > > cu -l /dev/tty0a -s 9600 > to get to my sparc, and I just get garbage back when I enter smth. > > When I try to connect to my procurve switch, > > cu -l /dev/tty09 -s 9600 > > then, the switch has speed autonegotiation, and connects fine with 1200 baud, > but not the desired 9600 baud. > > When I use /dev/tty03 (the first port of the PUC), then it takes the speed > values I give with cu -s correctly, and I can connect fine to the sparc, when > its there connected. > The problems start with tty04, and up to tty0a, I guess all those ports just > only take 1200 bauds. > > When I change back the CF card with the 4.6 installed, then all ports are > fine again, so I did not damaged anything while updating.
got an off-list reply (thanks), suggesting to try cua(4) instead of tty(4), but the problem persists. Sebastian > > anyone can help, dmesg below, and ls -l /dev/tty0* > > Sebastian > > OpenBSD 5.0-current (GENERIC) #118: Tue Dec 20 11:09:21 MST 2011 > dera...@i386.openbsd.org:/usr/src/sys/arch/i386/compile/GENERIC > cpu0: Geode(TM) Integrated Processor by AMD PCS ("AuthenticAMD" 586-class) > 500 MHz > cpu0: FPU,DE,PSE,TSC,MSR,CX8,SEP,PGE,CMOV,CFLUSH,MMX,MMXX,3DNOW2,3DNOW > real mem = 536408064 (511MB) > avail mem = 517550080 (493MB) > mainbus0 at root > bios0 at mainbus0: AT/286+ BIOS, date 20/80/26, BIOS32 rev. 0 @ 0xfac40 > pcibios0 at bios0: rev 2.0 @ 0xf0000/0x10000 > pcibios0: pcibios_get_intr_routing - function not supported > pcibios0: PCI IRQ Routing information unavailable. > pcibios0: PCI bus #0 is the last bus > bios0: ROM list: 0xc8000/0xa800 > cpu0 at mainbus0: (uniprocessor) > amdmsr0 at mainbus0 > pci0 at mainbus0 bus 0: configuration mode 1 (bios) > io address conflict 0x6100/0x100 > io address conflict 0x6200/0x200 > pchb0 at pci0 dev 1 function 0 "AMD Geode LX" rev 0x31 > glxsb0 at pci0 dev 1 function 2 "AMD Geode LX Crypto" rev 0x00: RNG AES > vr0 at pci0 dev 6 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 11, address > 00:00:24:c9:d4:98 > ukphy0 at vr0 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI > 0x004063, model 0x0034 > vr1 at pci0 dev 7 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 5, address > 00:00:24:c9:d4:99 > ukphy1 at vr1 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI > 0x004063, model 0x0034 > vr2 at pci0 dev 8 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 9, address > 00:00:24:c9:d4:9a > ukphy2 at vr2 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI > 0x004063, model 0x0034 > vr3 at pci0 dev 9 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 12, address > 00:00:24:c9:d4:9b > ukphy3 at vr3 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI > 0x004063, model 0x0034 > puc0 at pci0 dev 14 function 0 "Sunix 40XX" rev 0x01: ports: 8 com > com3 at puc0 port 0 irq 10: ti16750, 64 byte fifo > com3: probed fifo depth: 32 bytes > com4 at puc0 port 1 irq 10: ti16750, 64 byte fifo > com4: probed fifo depth: 32 bytes > com5 at puc0 port 2 irq 10: ti16750, 64 byte fifo > com5: probed fifo depth: 32 bytes > com6 at puc0 port 3 irq 10: ti16750, 64 byte fifo > com6: probed fifo depth: 32 bytes > com7 at puc0 port 4 irq 10: ti16750, 64 byte fifo > com7: probed fifo depth: 32 bytes > com8 at puc0 port 5 irq 10: ti16750, 64 byte fifo > com8: probed fifo depth: 32 bytes > com9 at puc0 port 6 irq 10: ti16750, 64 byte fifo > com9: probed fifo depth: 32 bytes > com10 at puc0 port 7 irq 10: ti16750, 64 byte fifo > com10: probed fifo depth: 32 bytes > glxpcib0 at pci0 dev 20 function 0 "AMD CS5536 ISA" rev 0x03: rev 3, 32-bit > 3579545Hz timer, watchdog, gpio > gpio0 at glxpcib0: 32 pins > pciide0 at pci0 dev 20 function 2 "AMD CS5536 IDE" rev 0x01: DMA, channel 0 > wired to compatibility, channel 1 wired to compatibility > wd0 at pciide0 channel 0 drive 0: <SanDisk SDCFH-002G> > wd0: 1-sector PIO, LBA, 1918MB, 3928176 sectors > wd0(pciide0:0:0): using PIO mode 4, DMA mode 2 > pciide0: channel 1 ignored (disabled) > ohci0 at pci0 dev 21 function 0 "AMD CS5536 USB" rev 0x02: irq 15, version > 1.0, legacy support > ehci0 at pci0 dev 21 function 1 "AMD CS5536 USB" rev 0x02: irq 15 > usb0 at ehci0: USB revision 2.0 > uhub0 at usb0 "AMD EHCI root hub" rev 2.00/1.00 addr 1 > isa0 at glxpcib0 > isadma0 at isa0 > com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo > com0: console > com1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo > pckbc0 at isa0 port 0x60/5 > pckbd0 at pckbc0 (kbd slot) > pckbc0: using irq 1 for kbd slot > wskbd0 at pckbd0: console keyboard > pcppi0 at isa0 port 0x61 > spkr0 at pcppi0 > nsclpcsio0 at isa0 port 0x2e/2: NSC PC87366 rev 10: GPIO VLM TMS > gpio1 at nsclpcsio0: 29 pins > npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16 > usb1 at ohci0: USB revision 1.0 > uhub1 at usb1 "AMD OHCI root hub" rev 1.00/1.00 addr 1 > mtrr: K6-family MTRR support (2 registers) > vscsi0 at root > scsibus0 at vscsi0: 256 targets > softraid0 at root > scsibus1 at softraid0: 256 targets > root on wd0a (ddc0d49aadbd07dc.a) swap on wd0b dump on wd0b > crw-rw---- 1 uucp dialer 8, 0 Dec 31 10:27 /dev/tty00 > crw-rw---- 1 uucp dialer 8, 1 Dec 31 10:27 /dev/tty01 > crw-rw---- 1 uucp dialer 8, 2 Dec 31 10:27 /dev/tty02 > crw-rw---- 1 uucp dialer 8, 3 Dec 31 10:27 /dev/tty03 > crw-rw---- 1 uucp dialer 8, 4 Dec 31 10:27 /dev/tty04 > crw-rw---- 1 uucp dialer 8, 5 Dec 31 10:27 /dev/tty05 > crw-rw---- 1 uucp dialer 8, 6 Dec 31 10:27 /dev/tty06 > crw-rw---- 1 uucp dialer 8, 7 Dec 31 10:27 /dev/tty07 > crw-rw---- 1 uucp dialer 8, 8 Dec 31 10:27 /dev/tty08 > crw-rw---- 1 uucp dialer 8, 9 Dec 31 10:27 /dev/tty09 > crw-rw---- 1 uucp dialer 8, 10 Dec 31 10:29 /dev/tty0a > crw-rw---- 1 uucp dialer 8, 11 Dec 31 10:27 /dev/tty0b