----- Original Message -----
From: "Damien Bergamini" <[EMAIL PROTECTED]>
Sent: Tuesday, November 28, 2006 7:26 AM
The "route" command is only necessary for plain IPoA.
For PPPoA, ppp will create the route for you.
Just put:
set device PPPoA:ueagle0:8.35
in your ppp.conf file.
That gives me:
/etc/ppp:4365$ sudo ppp adsl
Working in interactive mode
Warning: iface rm: ioctl(SIOCDIFADDR_IN6,
fe80:8::250:4ff:fe5d:1022/64): Can't assign requested address
Using interface: tun1
Command: adsl: set device PPPoA:ueagle0:8.35
Command: adsl: set authname [EMAIL PROTECTED]
Command: adsl: set authkey ********
ppp ON saltkudde> dial
Command: /dev/tty: dial
Warning: deflink: Device (PPPoA:ueagle0:8.35) must begin
with a '/', a '!' or contain at least one ':'
----
/etc/ppp:4366$ cat ppp.conf
default:
set log Phase Warning
add! default HISADDR
set ifaddr 0.0.0.1/0 0.0.0.2/0 255.255.255.0 0.0.0.0
set login
adsl:
set log local CCP Command DNS IPCP LCP TCP/IP Warning
set device PPPoA:ueagle0:8.35
set authname "[EMAIL PROTECTED]"
set authkey nytt95
# enable lqr
# enable dns
# disable ipv6cp
# set reconnect 10 100
---
/etc/ppp:4367$ dmesg
[EMAIL PROTECTED]:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: Intel Pentium III ("GenuineIntel" 686-class) 702 MHz
cpu0:
FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE
real mem = 133722112 (130588K)
avail mem = 114577408 (111892K)
using 1657 buffers containing 6787072 bytes (6628K) of memory
mainbus0 (root)
bios0 at mainbus0: AT/286+(32) BIOS, date 05/19/00, BIOS32 rev. 0 @ 0xfd890,
SMBIOS rev. 2.3 @ 0xebd60 (50 entries)
bios0: Dell Computer Corporation Inspiron 7500
apm0 at bios0: Power Management spec V1.2
apm0: battery life expectancy 100%
apm0: AC on, battery charge high, estimated 3:20 hours
apm0: flags 30102 dobusy 0 doidle 1
pcibios0 at bios0: rev 2.1 @ 0xfd890/0x770
pcibios0: PCI IRQ Routing Table rev 1.0 @ 0xfdf50/144 (7 entries)
pcibios0: PCI Interrupt Router at 000:07:0 ("Intel 82371FB ISA" rev 0x00)
pcibios0: PCI bus #3 is the last bus
bios0: ROM list: 0xc0000/0x10000
cpu0 at mainbus0
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
pchb0 at pci0 dev 0 function 0 "Intel 82443BX AGP" rev 0x03
ppb0 at pci0 dev 1 function 0 "Intel 82443BX AGP" rev 0x03
pci1 at ppb0 bus 1
vga1 at pci1 dev 0 function 0 "ATI Mobility 1" rev 0x64
wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
cbb0 at pci0 dev 4 function 0 "TI PCI1225 CardBus" rev 0x01: irq 11
cbb1 at pci0 dev 4 function 1 "TI PCI1225 CardBus" rev 0x01: irq 11
pcib0 at pci0 dev 7 function 0 "Intel 82371AB PIIX4 ISA" rev 0x02
pciide0 at pci0 dev 7 function 1 "Intel 82371AB IDE" rev 0x01: DMA, channel
0 wired to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 0 drive 0: <IBM-DARA-218000>
wd0: 16-sector PIO, LBA, 17301MB, 35433216 sectors
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2
atapiscsi0 at pciide0 channel 1 drive 0
scsibus0 at atapiscsi0: 2 targets
sd0 at scsibus0 targ 0 lun 0: <MATSHITA, LS-120 SLIM3 00, F710> SCSI0
0/direct removable
sd0: drive offline
atapiscsi1 at pciide0 channel 1 drive 1
scsibus1 at atapiscsi1: 2 targets
cd0 at scsibus1 targ 0 lun 0: <TOSHIBA, DVD-ROM SD-C2402, 1009> SCSI0
5/cdrom removable
sd0(pciide0:1:0): using PIO mode 0, DMA mode 1
cd0(pciide0:1:1): using PIO mode 4, Ultra-DMA mode 2
uhci0 at pci0 dev 7 function 2 "Intel 82371AB USB" rev 0x01: irq 5
usb0 at uhci0: USB revision 1.0
uhub0 at usb0
uhub0: Intel UHCI root hub, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
piixpm0 at pci0 dev 7 function 3 "Intel 82371AB Power" rev 0x02: SMI
iic0 at piixpm0
maestro0 at pci0 dev 8 function 0 "ESS Maestro 2E" rev 0x10: irq 5
ac97: codec id 0x83847609 (SigmaTel STAC9721/23)
ac97: codec features 18 bit DAC, 18 bit ADC, SigmaTel 3D
audio0 at maestro0
"AT&T/Lucent LTMODEM" rev 0x01 at pci0 dev 16 function 0 not configured
cardslot0 at cbb0 slot 0 flags 0
cardbus0 at cardslot0: bus 2 device 0 cacheline 0x0, lattimer 0x20
pcmcia0 at cardslot0
cardslot1 at cbb1 slot 1 flags 0
cardbus1 at cardslot1: bus 3 device 0 cacheline 0x0, lattimer 0x20
pcmcia1 at cardslot1
isa0 at pcib0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pms0 at pckbc0 (aux slot)
pckbc0: using irq 12 for aux slot
wsmouse0 at pms0 mux 0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
spkr0 at pcppi0
lpt0 at isa0 port 0x378/4 irq 7
npx0 at isa0 port 0xf0/16: using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
biomask ef6d netmask ef6d ttymask ffef
pctr: 686-class user-level performance counters enabled
mtrr: Pentium Pro MTRR support
xl0 at cardbus0 dev 0 function 0 "3Com Corporation, 3CCFE575BT, LAN Cardbus
Card": 3Com 3c575B-TX Ethernet: irq 11, address 00:50:04:5d:10:22
tqphy0 at xl0 phy 0: 78Q2120 10/100 PHY, rev. 3
ueagle0 at uhub0 port 1
ueagle0: Analog Devices Eagle III, rev 1.00/20.0b, addr 2
ueagle0: address: 00:60:4c:51:c7:80
dkcsum: wd0 matches BIOS drive 0x80
root on wd0a
rootdev=0x0 rrootdev=0x300 rawdev=0x302
-----
