Yeah It's hacked. I have 3 CIS-E and 1 Motronic injectors for about a year now.
I'd rather have CIS-E because they open @ lower pressure but I don't have a set
(one is really messed up) I have 2 sets of Motronic , but only 3 lines. When I
tested them all 4 opened @ the same time.By the way the compression on the 2.0
is 125 on all 4 cylinders. Bentley says 145 to 180 is new. That's a big drop. I
didn't lap the valve seats.They were a little rough. I was going to concentrate
on the 1.8 head and use the 2.0 while I take my time refreshing the 1.8 (maybe
a little porting & polishing) etc. Anyway the minimum is 109. It should run,
right??Found the spare O2 module. Gonna throw it in tomorrow. What the hay.Can
the exhaust/intake chain be off a tooth and still have even compression on all
4 cylinders??Steve----- Original Message -----From: ProFormance Date: Monday,
October 23, 2006 6:37 pmSubject: Re: [a2-16v-list] No power/low end on new
2.0To: [email protected]> Wait.. you using CIS-E (and)
Motronic injectors in combination? > They are > definitely different...> >
...unless I've missed something in a previous post...> > Ricky> > > > -----
Original Message ----- > From: > To: "Holland Phillips" > Cc: > Sent: Monday,
October 23, 2006 6:24 PM> Subject: Re: [a2-16v-list] No power/low end on new
2.0> > > >I was hoping you could pop the sprocket off w/out pulling the
cams...> >> > Other than a new O2 sensor I didn't touch any fuel delivery >
components > > until I started troubleshooting. I> > have a bad CIS-E
injector and a bad Motronic injector > line(melted it > > w/shop light) so I
have a mixed bag of> > injectors. Now I'm using a spare airbox, plugs, wires,
knock > module, > > ignition module. Can't find my spare> > DPR, coil or O2
control module or I would have swapped them > out as well. > > Did every
electrical test except the> > DPR.> > One doubt I have is the tach reading
higher than it should. I > think this > > happened to me before.> > Anyway
going to check compression and then probably open the > valve cover.> > Steve >
> _______________________________________________> a2-16v-list mailing list>
[email protected]>
http://mail.a2-16v.com/mailman/listinfo/a2-16v-list> For list archives, see
listinfo link above.>
