I would like to monitor the system temperature that is shown when one doe the show env command on the router. Would anyone know the OID that I would need to use to accomplish this or maybe have a better solution. I tried looking through the results of an snmpwalk for the router but that was of little help. If someone can help I would appreciate it.
________________________________ From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Hughes, Andy Sent: Friday, August 22, 2008 10:06 AM To: Steve Shipway; '[email protected]' Subject: Re: [mrtg] Newbie question Steve, thanks again. I have changed the task to run every 5 minutes, which currently means it fails every 5 minutes. Here is a snippet that appears after manually trying to run (community string and IP changed). The hosting provider swears they have not altered the community string. Does anything look obviously wrong? SNMPv1_Session (remote host: "10.10.10.10" [10.10.10.10].161) community: "xxxxxxx" request ID: 1304582469 PDU bufsize: 8000 bytes timeout: 2s retries: 5 backoff: 1) at C:/mrtg-2.16.2/bin\..\lib\mrtg2/SNMP_util.pm line 492 SNMPGET Problem for ifInOctets.1 ifOutOctets.1 sysUptime sysName on [EMAIL PROTECTED]::::::v4only <mailto:[EMAIL PROTECTED]::::::v4only> at mrtg line 2202 2008-08-19 09:04:54: WARNING: skipping because at least the query for ifInOctets .1 on 10.10.10.10 did not succeed 2008-08-19 09:04:54: WARNING: no data for ifInOctets&ifOutOctets:[EMAIL PROTECTED] 0.10.10.10. Skipping further queries for Host 10.10.10.10 in this round. ________________________________ From: Steve Shipway [mailto:[EMAIL PROTECTED] Sent: Friday, August 22, 2008 12:36 AM To: Hughes, Andy; '[email protected]' Subject: RE: Newbie question The location of error logs depends on your system setup; I can't help you there. MRTG will poll at 5min intervals by default only if you are using Daemon mode (you arent). Therefore, you should set your cron job to run every 5 mins, unless you have explicitly set a 10min interval (you havent). Steve ________________________________ From: [EMAIL PROTECTED] [EMAIL PROTECTED] On Behalf Of Hughes, Andy [EMAIL PROTECTED] Sent: Friday, 22 August 2008 5:15 a.m. To: '[email protected]' Subject: Re: [mrtg] Newbie question Steve, thanks very much for the response. I will pursue what you have suggested. I did search for some error logs but found none. Where are they hiding? Is mrtg by default going to run every 5 minutes without my intervention, or are you saying I should change the task to run every 5 minutes instead rather than the 10 I set up? Thanks again! Please consider the environment before printing this e-mail. CONFIDENTIAL NOTICE: This e-mail message and any attachment(s) (collectively, this 'Email') are intended only for the confidential use of the recipient(s) named above. If the reader of this message is not the intended recipient named above or an agent responsible for delivering it to the intended recipient named above, you have received this Email in error. Please notify the sender immediately and permanently delete this Email and any copies thereof.
_______________________________________________ mrtg mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg
