Am Fre, 2003-08-15 um 18.18 schrieb Greg Gilbert: [qcop]
> Even with OPIE, the qcop messages are for the best. You can send the > QPE/Sync flush() signal at the beginning of syncing. This instructs > the apps to save their data to the various data files. Once you are > done doing your syncing of the files you can send the QPE/Sync > reload() qcop message to instruct the apps to read in the new data > from files. I know that, this is exactly why we're working on this. My point is: Even now Multisync happily syncs with Opie as long as you make sure the PIM apps are not running while syncing. However, if I didn't completely misunderstand you, the 2.38 Sharp ROM PIM apps don't even seem to sync properly if QCop is not used. Naturally it is desirable for Multisync to properly work with the 2.38 Sharp ROM as well, therefore I was curious whether you did anything more special than the startSync/flush/sync/reload/stopSync sequence to make it work. Or was your original problem due to the fact that you tried to sync while one of the PIM apps was open/quickloaded? Regards, Eike -- Eike M. Lang <[EMAIL PROTECTED]> ------------------------------------------------------- This SF.Net email sponsored by: Free pre-built ASP.NET sites including Data Reports, E-commerce, Portals, and Forums are available now. Download today and enter to win an XBOX or Visual Studio .NET. http://aspnet.click-url.com/go/psa00100003ave/direct;at.aspnet_072303_01/01 _______________________________________________ Multisync-devel mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/multisync-devel
