Try using the latest ivtv. There were some fixes in the yuv stuff after 3.6k John --- Duncan Brown <[EMAIL PROTECTED]> wrote:
> Hey > > So its Friday, and I'm back to the point I left you > last. Just installed > the latest ivtv and utils by doing a make && make > install. Ivtvdev has > also been installed. > > Using xv results in a messed up green/black/purple > picture. Also I now > cannot change channel in live tv. The box goes > through the motions, and > even displays the right channel info, but it doesn't > actually change > channel. > > Here is the useful bit from messages > > Jun 17 14:08:57 Gobbla kernel: ivtv: > ==================== START INIT > IVTV ==================== > Jun 17 14:08:57 Gobbla kernel: ivtv: version 0.3.6 > (k) loading > Jun 17 14:08:57 Gobbla kernel: ivtv: Linux version: > 2.6.11-1.27_FC3 686 > REGPARM 4KSTACKS gcc-3.4 > Jun 17 14:08:57 Gobbla kernel: ivtv: In case of > problems please include > the debug info > Jun 17 14:08:57 Gobbla kernel: ivtv: between the > START INIT IVTV and END > INIT IVTV lines when > Jun 17 14:08:57 Gobbla kernel: ivtv: mailing the > ivtv-devel mailinglist. > Jun 17 14:08:57 Gobbla kernel: ivtv: Autodetected > WinTV PVR 350 card > Jun 17 14:08:57 Gobbla kernel: ivtv: Found an iTVC15 > based chip > Jun 17 14:08:57 Gobbla kernel: ACPI: PCI Interrupt > Link [LNKB] enabled > at IRQ 10 > Jun 17 14:08:57 Gobbla kernel: PCI: setting IRQ 10 > as level-triggered > Jun 17 14:08:57 Gobbla kernel: ACPI: PCI interrupt > 0000:00:09.0[A] -> > GSI 10 (level, low) -> IRQ 10 > Jun 17 14:08:57 Gobbla kernel: ivtv: Unreasonably > low latency timer, > setting to 64 (was 32) > Jun 17 14:08:57 Gobbla kernel: ivtv: VIA PCI device: > 0x3099 vendor: 0x1106 > Jun 17 14:08:57 Gobbla kernel: ivtv: Failed to load > module tveeprom > Jun 17 14:08:57 Gobbla kernel: ivtv: i2c client > addr: 0x50 not found for > command 0! > Jun 17 14:08:57 Gobbla kernel: ivtv: Error -19 > reading Hauppauge eeprom. > Jun 17 14:08:57 Gobbla kernel: ivtv: Possible > causes: the tveeprom > module was not loaded, or > Jun 17 14:08:57 Gobbla kernel: ivtv: the eeprom > kernel module was loaded > before the tveeprom module. > Jun 17 14:08:57 Gobbla kernel: tuner: Ignoring > new-style parameters in > presence of obsolete ones > Jun 17 14:08:57 Gobbla kernel: tuner: chip found at > addr 0xc2 i2c-bus > ivtv i2c driver #0 > Jun 17 14:08:57 Gobbla kernel: ivtv: i2c attach > [client=(tuner unset),ok] > Jun 17 14:08:57 Gobbla kernel: saa7115: starting > probe for adapter ivtv > i2c driver #0 (0x10005) > Jun 17 14:08:57 Gobbla kernel: saa7115: detecting > saa7115 client on > address 0x42 > Jun 17 14:08:57 Gobbla kernel: saa7115: writing init > values > Jun 17 14:08:57 Gobbla kernel: ivtv: i2c attach > [client=saa7115[50],ok] > Jun 17 14:08:57 Gobbla kernel: saa7115: status: (1E) > 0x00, (1F) 0xc0 > Jun 17 14:08:57 Gobbla kernel: saa7127: Ignoring > new-style parameters in > presence of obsolete ones > Jun 17 14:08:57 Gobbla kernel: saa7127: video > encoder driver version V > 0.3 loaded > Jun 17 14:08:57 Gobbla kernel: saa7127: detecting > saa7127 client on > address 0x88 > Jun 17 14:08:57 Gobbla kernel: saa7127: Selecting > NTSC video Standard > Jun 17 14:08:57 Gobbla rpcidmapd: rpc.idmapd startup > succeeded > Jun 17 14:08:57 Gobbla kernel: saa7127: Selecting > S-Video+Composite > Jun 17 14:08:57 Gobbla kernel: saa7127: Turn WSS off > Jun 17 14:08:57 Gobbla kernel: saa7127: Widescreen > Mode 4:3 Full Format > Jun 17 14:08:57 Gobbla kernel: saa7127: Selecting > Normal Encoder Input > Jun 17 14:08:57 Gobbla kernel: saa7127: Enable Video > Output > Jun 17 14:08:57 Gobbla kernel: ivtv: i2c attach > [client=saa7127[50],ok] > Jun 17 14:08:57 Gobbla kernel: ivtv: Failed to load > module msp3400 > Jun 17 14:08:57 Gobbla kernel: tda9885/6/7: chip > found @ 0x86 > Jun 17 14:08:57 Gobbla kernel: ivtv: i2c attach > [client=tda9887,ok] > Jun 17 14:08:57 Gobbla kernel: ivtv: Encoder > revision: 0x02040024 > Jun 17 14:08:57 Gobbla kernel: ivtv: Encoder > Firmware may be buggy, use > version 0x02040011 > Jun 17 14:08:57 Gobbla kernel: ivtv: Decoder > revision: 0x02020023 > Jun 17 14:08:57 Gobbla kernel: ivtv: Configuring > WinTV PVR 350 card with > 10 streams > Jun 17 14:08:57 Gobbla kernel: ivtv: Registered v4l2 > device, streamtype > 0 minor 0 > Jun 17 14:08:57 Gobbla kernel: ivtv: Create DMA > stream 0 using 128 16384 > byte buffers 0 kbytes total > Jun 17 14:08:57 Gobbla kernel: ivtv: Registered v4l2 > device, streamtype > 1 minor 32 > Jun 17 14:08:57 Gobbla kernel: ivtv: Create DMA > stream 1 using 161 12960 > byte buffers 0 kbytes total > Jun 17 14:08:57 Gobbla kernel: ivtv: Registered v4l2 > device, streamtype > 2 minor 224 > Jun 17 14:08:57 Gobbla kernel: ivtv: Create DMA > stream 2 using 165 12635 > byte buffers 0 kbytes total > Jun 17 14:08:57 Gobbla kernel: ivtv: Registered v4l2 > device, streamtype > 3 minor 24 > Jun 17 14:08:57 Gobbla kernel: ivtv: Create DMA > stream 3 using 455 4608 > byte buffers 0 kbytes total > Jun 17 14:08:57 Gobbla kernel: ivtv: Registered v4l2 > device, streamtype > 4 minor 64 > Jun 17 14:08:57 Gobbla kernel: ivtv: Create stream 4 > Jun 17 14:08:57 Gobbla kernel: ivtv: Registered v4l2 > device, streamtype > 5 minor 16 > Jun 17 14:08:57 Gobbla kernel: ivtv: Create DMA > stream 5 using 16 65536 > byte buffers 0 kbytes total > Jun 17 14:08:57 Gobbla kernel: ivtv: Registered v4l2 > device, streamtype > 6 minor 228 > Jun 17 14:08:57 Gobbla kernel: ivtv: Create DMA > stream 6 using 1024 2048 > byte buffers 0 kbytes total > Jun 17 14:08:57 Gobbla kernel: ivtv: Registered v4l2 > device, streamtype > 7 minor 232 > Jun 17 14:08:57 Gobbla kernel: ivtv: Create stream 7 > Jun 17 14:08:57 Gobbla kernel: ivtv: Registered v4l2 > device, streamtype > 8 minor 48 > Jun 17 14:08:57 Gobbla kernel: ivtv: Create DMA > stream 8 using 20 51840 > byte buffers 0 kbytes total > Jun 17 14:08:57 Gobbla kernel: ivtv: Create DMA > stream 9 using 32 65536 > byte buffers 0 kbytes total > Jun 17 14:08:57 Gobbla kernel: saa7115: decoder set > norm PAL > Jun 17 14:08:57 Gobbla kernel: saa7115: set audio: > 0x01 > Jun 17 14:08:57 Gobbla kernel: saa7115: decoder set > input (4) > Jun 17 14:08:57 Gobbla kernel: saa7115: now setting > Composite input > Jun 17 14:08:57 Gobbla kernel: ivtv: Setting audio > matrix to input 3, > output 1 > Jun 17 14:08:57 Gobbla kernel: ivtv: i2c client > addr: 0x40 not found for > command 1074294033! > Jun 17 14:08:57 Gobbla kernel: ivtv: i2c client > addr: 0x40 not found for > command 2150135312! > Jun 17 14:08:57 Gobbla kernel: ivtv: i2c client > addr: 0x40 not found for > command 1076393489! > Jun 17 14:08:57 Gobbla kernel: ivtv: Switching > standard to PAL. > Jun 17 14:08:57 Gobbla kernel: ivtv: i2c client > addr: 0x40 not found for > === message truncated === _______________________________________________ mythtv-users mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
