I was asking for support. My unit was working with John's monitor and tools. Unfortunately I don't have access to my system and can't look at the settings.
~~ _/) ~~~~ _/) ~~~~ _/) ~~~~ _/) ~~ On Dec 18, 2014, at 9:01 PM, Crusty OMO <[email protected]> wrote: Ok, I have finished the last parts, connectors, etc. The board is working! It's a little picky as to what kind of monitor it will run. It only works with 2 of 4 monitors I tried with it. But, that's ok. Now, Rich has indicated one configuration, does anyone else want to share their I/O configuration of this board? Who on the list was asking for the 8080 board to support this Console I/O? Thanks, Josh From: [email protected] To: [email protected] Subject: RE: [N8VEM-S100:5846] Propeller Console I/O Date: Wed, 17 Dec 2014 22:34:57 -0500 Hi Guys, I'm finished building this board, I'm in the final stages to configure. What is the most common address and status configuration? I realize it's configurable to match existing vintage software, but I'm hoping to list a few common setups that I can program in firmware. It's acceptable for more than one, since I can test for Status reaction and/or prompt each configuration for a response. Cheers, Josh -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
