At one point you mention a MYIDE ROM. I’m not familiar with that.
MYIDE, the .COM file, runs in CPM 2.2 on my CCS 2810 with a V2 IDE/CF card that I had to modify somewhat to get it to work. (If you are really in need of knowing what the modifications were, I could dig them up, but it might take some time…) However, I could not get drivers to run in my BIOS in order to use it through the file system. This was my motivation nearly a year ago to get a CPM3 system running (and have an easier go with the drivers.) And the rest a is a very long story that still has no end! I have a V3 IDE/CF card sitting here to build, hoping that the combination of V3 and CPM3 will be a winner, cause my 8” disks are getting real old. I also have a CCS 2422 floppy controller with three 8” and one 5 ¼” drives, and a dual console setup consisting of a Fulcrum IVI S-100 card and a serial terminal on the 2810’s serial port. Bob Bell From: [email protected] [mailto:[email protected]] Sent: Tuesday, July 14, 2015 12:04 PM To: [email protected] Subject: Re: [N8VEM-S100:7397] Re: V3 Dual IDE/CF S100 Bus board initial checks Hi Jeff -- >> Had some time to work with my v.3 IDE/CF card today after completing >> assembly. I've assembled one of mine. Can't get it to work either. Can't write to the 8255 ports, but I can read from them. That's a complete wipe-out for me. Couldn't get V1, V2 or V3 to work. >> - Can MYIDE.COM run on an 8080 or 8085 CPU? Don't know. >> - Can MYIDE.COM run under cp/m 2.2? cp/m3 NOT required for MYIDE.COM test / >> utility program? Sure. I've been using the single CF version of MYIDE on cp/m 2.2. I've got the source for it in (cleaner) Z80 assembler, if that would help? But *NOT* the dual CF version. Haven't tried to work with that yet. >> Has anyone, maybe Bob Bell, ever run the MYIDE ROM on the California >> Computer Systems (CCS) 2810 Z80 CPU? I have a CCS 2810 (actually two), but I've not tried it with that CPU. I'm running it on a CompuPro CPU-Z (@ 4MHz). Roger -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
