Hi Mike & René, After checking René's pinout with my own DC106A's I see that there are different versions of the DC106A modules so you should check what version you have before connecting them! Some of these have an extra sticker on top of the Burroughs sticker saying that they were modified by "Babcock" and they actually more looks like the DC105D units in pinout, but they all have the nixie numbers connected on the top connectors. To me it looks like these DC106A were rewired with the reset signal on pin 7 to be exchangeable with the DC105D units, there might have been more modifications done that I can't check as all my DC106A units are modified in the same way.
My DC106A units have the following pinout: Bottom Connector (left-to-right, viewed from rear): 1 - Filaments, 6.3V 2 - Filaments, 6.3V 3 - B+ Supply, 300V 4 - BD Tube Clear (0.001uf cap coupling to BD-301 cathode) 5 - Input (50-60V negative pulse, rising edge <1usec) 6 - Cascade Output 7 - BD Tube Reset (24pf cap coupling to BD-301 spade 9) 8 - Ground 9 - N/C 10 - N/C On 10 Okt, 05:23, mjrippe <[email protected]> wrote: > Hello, > > This is Mike (formerly yellow74ghia), and I just wanted to say two > things. First thanks to René for figuring out the error in the data I > shared and for getting a working circuit together. Second, credit for > the original data that I shared goes to Jeff Malins who was helping me > figure out my DC-106, although I never quite got it running. > Hopefully with this new info I will be able to do so when I get the > time. > > Mike -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To post to this group, send an email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/neonixie-l?hl=en-GB.
