Mike's power supplies have a "pulse" output to where you can tie a mutiplier to get higher output voltage than what the board alone offers.
https://threeneurons.wordpress.com/nixie-power-supply/hv-supply-kit/ In one of the examples in that page you have one showing 310V, etc. From back of the envelope calculations one can get not more than 15 mA out of each module at 300V... On Monday, July 15, 2019 at 4:01:33 PM UTC-3, Dekatron42 wrote: > > Hi, > > I've tried to find a small switching PSU module that can output > 300VDC@40mA to drive six (6) GR10G Nixies - their minimum voltage is 220VDC > but most work a lot better with closer to 300VDC (250-300VDC in the > datasheets). > > I've emailed the usual suspects, Tayloredge and Michael Moorrees, without > receiving an answer if their modules can be modified to output 300VDC but I > haven't received an answer from any of them. > > So, does anyone here have design of a power supply that can power six (6) > GR10G at 300VDC@40mA? > > I can use more than one module if power requirements are too much for just > one module, size is not that important and I might go with a small R-Core > 30VA transformer or a dual transformer design if no module exists. > > /Martin > -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send an email to [email protected]. To view this discussion on the web, visit https://groups.google.com/d/msgid/neonixie-l/3dd89fd1-9e6f-4d87-9466-7e6c9bc8346a%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
