I have a B7971 that doesn't want to light up - the ends of some segments will glow, but none will illuminate along their entire length. I have had tubes in the past that were probably a bit gassy, and they cleaned up after running for a few minutes to a few hours.
So, I put it into the "10 second" position of my Mod 6 clock, and ran it over night with no improvement. However after I had been up an hour or so, I noticed that the tube's segments were lighting up along about 3/4 of their lengths, and also that the low morning sun was shining on the clock. This state lasted for as long as the sunlight was on the tube - sometime after light moved off of the clock, the tube went back to it's wounded state. This morning I watched as the sunlight moved toward the clock, and as soon as the light hit the clock, the tube immediately recovered, and performed like it did yesterday. However, that state lasted for about 3-1/2 hours after the sunlight moved away. I then shined a flashlight on the tube, and it recovered as long as the light was there. I guess this is some kind of photo-voltaic effect. I have a bit of education in basic physics (for engineering), and this baffles me - but it's cool! I have a reading lamp that puts out a full spectrum, so I will put that on the clock today and see what happens. I may also set up a test to run the tube at a bit higher voltage (180-ish V). It may never recover completely, but I think this is a fun exercise. Anyway, and ideas are welcome. I may not be able to save the tube, but I might actually learn something. Thanks. Jim -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web, visit https://groups.google.com/d/msgid/neonixie-l/d2784c4a-c76f-4ae6-b0b1-86f14185bb22n%40googlegroups.com.
