Hello Duncan McGregor ([EMAIL PROTECTED]),
You wrote about "[netconnect] HyperCom1 Cards",
on 8 Jul 99 21:48:42 +0000.
> I need some help:
>
> I have just got my hypercom1 card from ACTIVE, installed it perfectly,
> but when selecting it as my main device "HYPERCOM1.device", it isn't
> recognised by either Genesis or any Netconnect prog for that matter.
>
> I have spoken with Chris and VMC and they both put it down to Rom
> Mappers but I have none whatsoever and my startups sequences are as
> clean as a whistle.
> Quick config: A1200, Magnum 030, 16MB, 32X CD, 810MB 2.5" Hard Drive.
Are you trying the latest drivers off the VMC website (Dated 14.6.99)?
If so then you may find that they are bugged. This is the case with
their latest drivers for my Hypercom3Z. The previous beta
(released a week or so before) suffered the same problem as well. Not
one program I have can open either of my serial ports with any of
these driver releases. This includes serial mouse drivers.
Also either VMC are on holiday or just ignored my reports on both of
these driver releases. There website is now also 99% german which I
find very helpfull.
Just an idea.
--
Jason Watson.
====================================================
Towerised A4K, WB3.1, CS-PPC 060-60 604-200 2+64MB,
CV-643D 4MB (CGfx4.1), 2.1GB IDE (PFS2), Atapi ZIP,
6x2x2 CD-RW (IDEFix97 3.4). Dynalink 33.6 Modem (NC v 2.3)
====================================================
_____________________________________________________________
NetConnect mailing list. To unsubscribe, send an 'unsubcribe'
message to <[EMAIL PROTECTED]>
