Patrick Ford <[EMAIL PROTECTED]> wrote:
> On 07-Nov-99, Andrew Bruno wrote:
> > So if I get the 8N1.device how do I change the whole lot over to use
it?
> >
> In every program that uses the serial device, find where the device is
set
> and change it to 8n1.device. Don't try what I did the first time I got
it and
> think you can cheat by renaming 8n1.device to serial.device. It
doesn't
> work
If you use artser.device from aminet you can do this
file: ArtSer37_6.lha
Its older than the 8N1.device, but it works quite well
for some people.
-- start snap from readme.file (aminet) --
If you cannot set the device in your comms program, don't despair.
Rename your old serial device to devs:oldser.device or something
similar, and rename artser.device to devs:serial.device.
Then edit or zap this file, and replace the two occurences of the
string "artser" with "serial". If you already have used your comms
package since last reboot, you might have to reboot again before the
change will have any effect.
-- end snap from readme.file (aminet) --
The last part meaning you'll have to find an editor that
handles binary and edit the file artser.device
--
Anbjoern Myren, Norway, A4000/040, IRC: Anmy, http://home.sol.no/~amyren
_____________________________________________________________
NetConnect mailing list. To unsubscribe, send an 'unsubcribe'
message to <[EMAIL PROTECTED]>
