Hello Anbjoern
On 08-Nov-99, you wrote:
> If you use artser.device from aminet you can do this
> file: ArtSer37_6.lha
> Its older than the 8N1.device, but it works quite well
> for some people.
>
> -- start snap from readme.file (aminet) --
>
> If you cannot set the device in your comms program, don't despair.
> Rename your old serial device to devs:oldser.device or something
> similar, and rename artser.device to devs:serial.device.
> Then edit or zap this file, and replace the two occurences of the
> string "artser" with "serial". If you already have used your comms
> package since last reboot, you might have to reboot again before the
> change will have any effect.
>
> -- end snap from readme.file (aminet) --
>
> The last part meaning you'll have to find an editor that
> handles binary and edit the file artser.device
>
> --
> Anbjoern Myren, Norway, A4000/040, IRC: Anmy, http://home.sol.no/~amyren
Thanks.
The 8N1 device is getting a bit of a mention. I think I will go with it.
But from the replies, it seems I asked the wrong question.
What I meant to ask was (for instance) if I want to use the 8n1.device
instead of the serial.device, how to I get netconenct (genesis) to use it.
Do I just go into genesie_prefs and change it there?
If so, as a check...
Which are the places I do it?
:)
Sorry for the confusion.
Regards
--
It stinks more every time you run over a skunk..
Andrew Bruno
[EMAIL PROTECTED]
_____________________________________________________________
NetConnect mailing list. To unsubscribe, send an 'unsubcribe'
message to <[EMAIL PROTECTED]>
