Lamar McLouth said,
>>> What is the command to correct for this "Retrain Failure"?
>>
>> Say Damn, but at least it's unmetered, unlike the poor UK suckers
> I was referring to a Hayes command that either disables retrains or
> changes the conditions of the retrain.
+MS sets the maximum and minimum connect speeds. Set these to the same
value and retrains are disabled. However, that probably means that
you'll get dumped offline if the modem's not allowed to retrain, because
you're trying to fix the symptom, not the cause. It's a bit like fixing
low oil pressure in your car by taking the bulb out of the warning
light.
Neil
--
Neil Bothwick - New Media Editor, Amiga Active Magazine
Connected via Wirenet - http://www.wire.net.uk
The UK's first Amiga-only internet access provider
--
Your computer is dead, and it was so alive.
You shouldn't have installed... Win'95.
_____________________________________________________________
NetConnect mailing list. To unsubscribe, send an 'unsubcribe'
message to <[EMAIL PROTECTED]>
