--- Begin Message ---
------100120200109001057NTI
>i have the cable, and have made the changes to my config.sys file.
>as told.
>now, when i boot the receiving computer i am typing
>intersrv
>and pressing enter.
First, at that point, you should have a dos window showing the server
(or the "receiving conputer") waiting for a signal from the other conputer.
And you have to boot this one now (or after boot reenter the interlnk
command)
>my speach is only runing on the source computer, so i amnot sure
>what message if any i am getting on the receiving computer.
>however if i run msd to check for the drive on the receiving
>computer i get the following.
>my a, b, and c, drives on the source computer
>a d, e, f, drive which are listed as flopy drives with one cilnder,
>and a g drive which is the cd rom drive on my source computer.
>if i try to read either the d, e, or f, drive i get a drive not
>ready error. however i can read the g.
Something is strange : interlnk can not permit access to CDROM of the server
>i have two questions,
>1, is there a better way to learn if one of the drives is the drive
>from the receiving computer?
You should see a star * blinking on the receiving computer during access
>and
>2, are there any commands at all that should be done on the
>receiving computer save typing
>intersrv?
include it in autoexec.bat
>wait there is onemore.
>what should be the order of boot to insure i am getting the right
>data in the first place?
the server first the other afterwards
>thanks,
>karen
De rien
Gontran
Net-Tamer V 1.11.2X - Registered
------100120200109001057NTI--
********************************************************
To unsubscribe from this list,
send a message to [EMAIL PROTECTED] with the single word
Unsubscribe
as the subject.
You MUST use the same address with which you subscribed!
********************************************************
--- End Message ---
