Exhaust pipe clamps: try brushing with wire brush and then use
'Extend' rust treatment on them as a primer and either leave that way
or paint silver or black finish (all in spray cans).
Fender: the fenders on my CB650's are plastic
Base plate: I have no idea what that could be
Exhaust pie end: I have restored several of those - again use wire
brush and/or steel wool and then masking off everything else, paint
satin black with 500 degree or greater paint. Comes out real nice.
Headlight and around: steel wool - if that doesn't remove it replace.
I use steel wool a lot and have brought many rusted chrome surfaces
back to reasonably good condition. The older 80's chrome is pretty
durable,
Graham
On Jul 4, 2011, at 10:24 PM, Katie Lamb wrote:
On Mine the exhaust pipe clamps and the fender. Also a plate in the
base of the motor where the carburetors sit. The end that sits
inside the exhaust pipe. Some of the bits around the headlight.
Probably more.
I have scrubbed them. But may end up buying pieces each payday till
I can get the bike the way I wish it would be.
~Katie Lamb
On Jul 4, 2011 10:16 PM, "Graham Rogers" <[email protected]> wrote:
what's rusted?
On Jul 4, 2011, at 10:11 PM, Katie Lamb wrote:
> I have been watching your post I was hoping some...
--
You received this message because you are subscribed to the Google
Groups "Nighthawk Motorcycle ...
--
You received this message because you are subscribed to the Google
Groups "Nighthawk Motorcycle Lovers!" group.
To post to this group, send email to
[email protected].
To unsubscribe from this group, send email to nighthawk_lovers
[email protected].
For more options, visit this group at http://groups.google.com/
group/nighthawk_lovers?hl=en.
--
You received this message because you are subscribed to the Google Groups "Nighthawk
Motorcycle Lovers!" group.
To post to this group, send email to [email protected].
To unsubscribe from this group, send email to
[email protected].
For more options, visit this group at
http://groups.google.com/group/nighthawk_lovers?hl=en.
