i looks like no broken cable and the arm does move. can wrong torque level or a slightly loose clutch plate cause this clutch to suddenly not work?
what cleaner would you recommend for the chain? thx On Apr 3, 9:42 am, Kurt Nolte <[email protected]> wrote: > I would recommend against a hand cleaner for your chain. I'd figure it more > expensive than an actual cleaning fluid, and some of them have grit in them > that you most definitely DO NOT want. > > As for your clutch issue: cable broken internally? Does the arm move when > you squeeze the lever? > > Kurt > On Apr 3, 2012 12:35 PM, "dapperdan7" <[email protected]> wrote: > > > > > > > > > hi there. the clutch on my 91 250 nighthawk suddenly stopped > > disengaging clutch with little warning. when i opened up and looked at > > the plate one bolt was loose but everything else (clutch lifter and > > spring) seemed to work fine. > > > question on clutch: > > the manual says 12 nm for torque on the bolts. can one over tighten > > the plate so much that the lifter and plate don't interact? if the > > plate in undertorqued what would be the effects? just trouble shooting > > > question on chain: > > > can one clean the gunk off the chain with the orange goop one uses to > > clean hands? what would you guys recommend? > > > thank you gentlemen! > > > dan > > > -- > > You received this message because you are subscribed to the Google Groups > > "Nighthawk Motorcycle Lovers!" group. > > To post to this group, send email to [email protected]. > > To unsubscribe from this group, send email to > > [email protected]. > > For more options, visit this group at > >http://groups.google.com/group/nighthawk_lovers?hl=en. -- You received this message because you are subscribed to the Google Groups "Nighthawk Motorcycle Lovers!" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/nighthawk_lovers?hl=en.
