2 - Refer to number 1.
3 - Run check disk. I do not know if you can do it from TS.
4 - I would check the cables first. Replace the hard drive cable with a new one and see what happens.
5 - In the same error occurs, replace the hard drive.
6 - Did you do numbers 1 and 2 yet?
At 03:51 PM 12/9/2002 -0500, you wrote:
Been getting this lately on my Win2k Server: *** Event Type: Error Event Source: Disk Event Category: None Event ID: 7 Date: 12/9/2002 Time: 3:43:10 PM User: N/A Computer: MACHINENAME Description: The device, \Device\Harddisk0\DR0, has a bad block. Data:<snip> ***A short bit of research says this is because the drive is going. Attempting a chkdsk says 'cannot open volume for direct access'; would that be because I'm using Terminal Services to connect to it? Either way, the drive is/will be bad? Thanks. .salvatore http://sienar.org/ http://palmisanonet.com/ ------ You are subscribed as [EMAIL PROTECTED] Archives: http://www.swynk.com/sitesearch/search.asp To unsubscribe send a blank email to %%email.unsub%%
------ You are subscribed as [email protected] Archives: http://www.swynk.com/sitesearch/search.asp To unsubscribe send a blank email to [EMAIL PROTECTED]
