I ran the backups again when I noticed this (and they run every night). I'll attach a monitor and keyboard to the box and run the checkdisk as well.
Lets hope they approve a new hard drive for the system... Thanks for the quick replies. .salvatore http://sienar.org/ http://palmisanonet.com/ -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of Jacob Sent: Monday, December 09, 2002 4:00 PM To: NT 2000 Discussions Subject: Re: Bad Block Event Log 1 - Start backing up data... NOW... before you even finish reading this email. 2 - Refer to number 1. 3 - Run check disk. I do not know if you can do it from TS. 4 - I would check the cables first. Replace the hard drive cable with a new one and see what happens. 5 - In the same error occurs, replace the hard drive. 6 - Did you do numbers 1 and 2 yet? At 03:51 PM 12/9/2002 -0500, you wrote: >Been getting this lately on my Win2k Server: > >*** >Event Type: Error >Event Source: Disk >Event Category: None >Event ID: 7 >Date: 12/9/2002 >Time: 3:43:10 PM >User: N/A >Computer: MACHINENAME >Description: >The device, \Device\Harddisk0\DR0, has a bad block. Data:<snip> >*** > >A short bit of research says this is because the drive is going. >Attempting a chkdsk says 'cannot open volume for direct access'; would >that be because I'm using Terminal Services to connect to it? > >Either way, the drive is/will be bad? > >Thanks. > >.salvatore >http://sienar.org/ >http://palmisanonet.com/ > > >------ >You are subscribed as [EMAIL PROTECTED] >Archives: http://www.swynk.com/sitesearch/search.asp >To unsubscribe send a blank email to %%email.unsub%% ------ You are subscribed as [EMAIL PROTECTED] Archives: http://www.swynk.com/sitesearch/search.asp To unsubscribe send a blank email to %%email.unsub%% ------ You are subscribed as [email protected] Archives: http://www.swynk.com/sitesearch/search.asp To unsubscribe send a blank email to [EMAIL PROTECTED]
