Jay, Yes, I'm currently using the server with be2iscsi, non-multipath, and against an IET target. The problem seems to mainly occur when the traffic being passed is very low. I'll post a wireshark dump in a couple of hours.
Thanks, Seth On 12 July 2011 19:40, <jayamohan.kallic...@emulex.com> wrote: > Hi > > Any update? Did you try with non-multipath and ietd > > Thanks > Jay > > -----Original Message----- > From: Kallickal, Jayamohan > Sent: Friday, July 08, 2011 10:58 AM > To: open-iscsi@googlegroups.com; 'Mike Christie' > Cc: Seth Simons > Subject: RE: unable to login to targets with be2iscsi > > Seth, > > The CQ Error 13 is done mostly when a Fin is received. If the same > problem can be repro'd on iet , can you pl capture the wireshark trace on the > target. That would be very helpful. > > Also, if NOP's are being sent ,then, I would assume the traffic is low and > wireshark would not drop packets.. > > Thanks > Jay > > -----Original Message----- > From: open-iscsi@googlegroups.com [mailto:open-iscsi@googlegroups.com] On > Behalf Of Mike Christie > Sent: Wednesday, July 06, 2011 7:54 PM > To: open-iscsi@googlegroups.com > Cc: Seth Simons > Subject: Re: unable to login to targets with be2iscsi > > On 07/04/2011 08:34 AM, Seth Simons wrote: >> Yep, I do see those. I figured they were from the iscsi layer. Is it >> worth validating the configuration first *without* using multipath? >> It's fairly trivial to disable. The only reason i've not tried this >> yet is that the same problem happened when using a non-multipath >> target (single target on a linux box using ietd). I'm starting to > > I was re-reading this and saw this. So you have tried be2iscsi with iet > and it was showing the same problem? Or at least it had the problem > where you see: > > > [ 2811.027636] (beiscsi_process_cq():1953):CQ Error 13, reset CID 0x40... > > -- > You received this message because you are subscribed to the Google Groups > "open-iscsi" group. > To post to this group, send email to open-iscsi@googlegroups.com. > To unsubscribe from this group, send email to > open-iscsi+unsubscr...@googlegroups.com. > For more options, visit this group at > http://groups.google.com/group/open-iscsi?hl=en. > > -- You received this message because you are subscribed to the Google Groups "open-iscsi" group. To post to this group, send email to open-iscsi@googlegroups.com. To unsubscribe from this group, send email to open-iscsi+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/open-iscsi?hl=en.