Kesick, Nicholas Charles wrote:
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Marck
Sent: Tuesday, August 10, 2010 2:42 AM
To: [email protected]
Subject: Re: [Opensim-users] Hypergrid 0.7.0.1+
Kesick, Nicholas Charles wrote:
Hello all,
I waited until the ROBUST conversion was completed before wanting to try
setting up my own hypergrid.
Unfortunately the Wiki hasn't been updated yet for 0.7
(http://opensimulator.org/wiki/ROBUST). Would anyone be able to
contribute (either on the wiki or by email) a basic guide for a fresh
install to running a hypergrid?
I have ROBUST running, but I can't figure out what to do next. I try to
start OpenSim (mono OpenSim.exe) and it fails when initializing the
friends module. I did make sure to copy the GridCommon.ini, and make the
appropriate changes in OpenSim.ini (under Architecture, added ; before
Standalone, removed from StandaloneHypergrid)... but the directions aren't
clear on the steps to get a grid running.
Thanks in advance,
- Nicholas Kesick
Now at [email protected]<mailto:[email protected]>!
Hello Nicholas,
To enable hypergrid with Robust, you'll need to use Robust.HG.ini:
mono Robust.exe -inifile=Robust.HG.ini
For the simulators that you want to run with Robust, use an OpenSim.ini which
includes GridHypergrid.ini in section [Architecture], not
StandaloneHypergrid.ini.
Also, http://opensimulator.org/wiki/ROBUST#An_Example_Conversion_From_URM_To_R
has some interesting tidbits on hypergrid with Robust and how Robust 0.7
generally works. I guess you already have read
http://opensimulator.org/wiki/0.7_Release
_______________________________________________
Opensim-users mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/opensim-users
I did read them earlier, and reviewed them while making another attempt. I've gotten
closer (after 3 takes today)... ROBUST now shows when my region starts up ( :D ). ROBUST
says the region was successfully registered, and OpenSim says that logins are enabled.
Unfortunately, I can't log in. Hippo viewer immediately (and I mean immediately) says
"Login Failed", but no reason why. Neither ROBUST nor OpenSim show even an
attempted login. I've checked username and password (even created a second account), and
checked the address and gridname.
- Nicholas Kesick
In the viewer, are you using as LoginURI the same address that you have set for
parameter ExternalName in section [GatekeeperService] in Robust.HG.ini?
_______________________________________________
Opensim-users mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/opensim-users
