I had some trouble with the USB to serial converter. It used to work on
Cutecom. Now the program can't open /dev/ttyUSB0. Anyway, I figured out
minicom. Kind of crude but it does the job. [Besides, the 1989's were
good times.]
Here is the output from minicom:
U-Boot SPL 2013.04-dirty (Jul 10 2013 -
14:02:53) musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx,
HB-ISO Tx, SoftConn) musb-hdrc: MHDRC RTL version
2.0 musb-hdrc: setup fifo_mode
4 musb-hdrc: 28/31 max ep, 16384/16384
memory USB Peripheral mode controller at 47401000 using PIO, IRQ
0 musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx,
SoftConn) musb-hdrc: MHDRC RTL version
2.0 musb-hdrc: setup fifo_mode
4 musb-hdrc: 28/31 max ep, 16384/16384
memory USB Host mode controller at 47401800 using PIO, IRQ
0 OMAP SD/MMC:
0 mmc_send_cmd : timeout: No status
update reading
u-boot.img reading
u-boot.img
U-Boot 2013.04-dirty (Jul 10 2013 -
14:02:53)
I2C:
ready DRAM: 512
MiB WARNING: Caches not
enabled NAND: No NAND device
found!!! 0
MiB MMC: OMAP SD/MMC: 0, OMAP SD/MMC:
1 *** Warning - readenv() failed, using default
environment
musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx,
SoftConn) musb-hdrc: MHDRC RTL version
2.0 musb-hdrc: setup fifo_mode
4 musb-hdrc: 28/31 max ep, 16384/16384
memory USB Peripheral mode controller at 47401000 using PIO, IRQ
0 musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx,
SoftConn) musb-hdrc: MHDRC RTL version
2.0 musb-hdrc: setup fifo_mode
4 musb-hdrc: 28/31 max ep, 16384/16384
memory USB Host mode controller at 47401800 using PIO, IRQ
0 Net: <ethaddr> not set. Validating first E-fuse
MAC cpsw,
usb_ether Hit any key to stop autoboot:
0 gpio: pin 53 (gpio 53) value is
1 mmc0 is current
device micro SD card
found mmc0 is current
device gpio: pin 54 (gpio 54) value is
1 SD/MMC found on device
0 ** File not found uEnv.txt
** gpio: pin 55 (gpio 55) value is
1 ** File not found /boot/uImage
** U-Boot#
Looks to me like it found the SD card but doesn't boot. This is using
openSUSE-13.1-ARM-JeOS-beaglebone.armv7l-1.12.1-Build33.3.raw.xz
--
To unsubscribe, e-mail: [email protected]
To contact the owner, e-mail: [email protected]
