gpio_regulator has to be included into initrd to make mmc working. 25.11.2017 21:27, Matwey V. Kornilov пишет: > > Hm. It refuses to boot after KIWI deployed. For some reason > dracut-generated initrd failed to obtain /dev/mmcblk? devices. > > 14.11.2017 15:05, Matwey V. Kornilov пишет: >> Now It is booting. >> >> Now, I cannot figure out how to configure networking: >> >> 2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP >> group default qlen 532 >> link/ether 00:51:82:11:22:00 brd ff:ff:ff:ff:ff:ff >> inet6 fe80::251:82ff:fe11:2200/64 scope link >> valid_lft forever preferred_lft forever >> 3: wan@eth0: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN >> group default qlen 1000 >> link/ether 00:51:82:11:22:00 brd ff:ff:ff:ff:ff:ff >> 4: lan0@eth0: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN >> group default qlen 1000 >> link/ether 00:51:82:11:22:00 brd ff:ff:ff:ff:ff:ff >> 5: lan1@eth0: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN >> group default qlen 1000 >> link/ether 00:51:82:11:22:00 brd ff:ff:ff:ff:ff:ff >> >> 2017-11-14 14:48 GMT+03:00 Matwey V. Kornilov <matwey.korni...@gmail.com>: >>> mSD card is enabled in kernel dtb file only in 4.14. >>> >>> https://github.com/torvalds/linux/commit/9be778f6c6d8f90ff2fad88d1770e2a7843aee43 >>> >>> 2017-11-14 14:09 GMT+03:00 Matwey V. Kornilov <matwey.korni...@gmail.com>: >>>> Well, 4.13.12-1-default has issues with mmc-driver, so KIWI cannot >>>> find boot device. >>>> >>>> [ 9.651177] sdhci: Secure Digital Host Controller Interface driver >>>> [ 9.651182] sdhci: Copyright(c) Pierre Ossman >>>> [ 9.652213] sdhci-pltfm: SDHCI platform and OF driver helper >>>> [ 9.655798] xenon-sdhci d00d0000.sdhci: failed to get IRQ number >>>> [ 9.655809] xenon-sdhci d00d0000.sdhci: sdhci_pltfm_init failed -6 >>>> >>>> I will see, if different version of dtb file helps. >>>> >>>> -- >>>> With best regards, >>>> Matwey V. Kornilov >>> >>> >>> >>> -- >>> With best regards, >>> Matwey V. Kornilov >> >> >> > >
-- To unsubscribe, e-mail: opensuse-arm+unsubscr...@opensuse.org To contact the owner, e-mail: opensuse-arm+ow...@opensuse.org