On Sat, Jun 09, 2012 at 01:43:18PM +0100, Tim Fletcher wrote:
> >>Full envreset and without the ath9k pcie card still produce the same
> >>results, even with know good uboot binaries I guess either the
> >>iconnect is duff or I'm missing some obvious.
> >uboot has nothing to do what is connected to pcie (imho). Do you have
> >jtag? I found this:
> >
> >http://hardsoftmix.blogspot.com/
> >
> >I'll double check later the init values that he uses in his patch
> >(attached).
>
> I've not got a jtag for the board but I understand how it works,
> I've tried his prebuild uboot binary but he has only put up a .kwb
> which as I understand it has a 200byte header on that you need to
> allow for with the go command?
Where did you see that?
> If I understood the process right you need to tftp it to 0x800000
> and then go from 0x800200
No. I could try chainloading from my board later if you want.
> That binary also fails with the same CPU reset if I try and chain it.
His patch has all the same kwb values as mine does... I think that my
patch should work. There are now two options for testing this, you try
to flash this on your board and see if it works and if it does not work:
1) you get jtag and reflash your original bootloader
2) you send me your board and I make it work here (once I'm done I will
return the board)
Do you like any of this options? I dont see the third one...
Luka
_______________________________________________
openwrt-devel mailing list
[email protected]
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
