I could finally boot 3.18 by loading the rootfs from USB: http://pastebin.com/b4dX0X7B
Everything seems to be working fine, still no clue about the SD issues... http://pastebin.com/G61ALvLX El 10/02/2015 a las 11:09, Álvaro Fernández Rojas escribió: > The pins you said are the right ones. However, if anything fails before the > kernel is booted you won't get any output. You could try booting a 3.14 image > and check if you are properly connected to the uart. > > It may be some wrong configuration related to the recently added DT support, > which expects a DTB and since no DTB is passed from the bootloader, the > kernel crashes before any output. > >> El 10/2/2015, a las 6:29, John Crispin <[email protected]> escribió: >> >> ok, so uart, how do you connect it ? >> >>> On 10/02/2015 02:02, Álvaro Fernández Rojas wrote: >>> I tried adding support for 3.18 and I have issues booting the raspberry. >>> There must be something wrong with the new mmc driver, because it detects >>> the SD card insertions/extractiones, but doesn't read the partitions: >>> http://pastebin.com/GWFYrXnT >>> >>> My patches: >>> http://files.noltari.es/openwrt/bcm2708/brcm2708_3-18.tgz >>> >>> Regards, >>> Álvaro. >>> >>>> El 09/02/2015 a las 18:12, Florian Fainelli escribió: >>>>> On Feb 9, 2015 4:25 AM, "John Crispin" <[email protected] >>>>> <mailto:[email protected]>> wrote: >>>>> >>>>> Hi, >>>>> >>>>> i synced our rpi port with the upstream tree on github. it boots and i >>>>> can see the coloured palette test pic on the hdmi, however ethernet >>>>> fails to come up. i attached a uart just to find out that my rpi is >>>>> either broken or i am connecting it wrong. >>>>> >>>>> has anyone managed to get uart working ? to my understanding i need to >>>>> connect pin6 to gnd and use 8 and 10 for the 2 data lines. should i see >>>>> output from the bootloader prior to board detecting/loading the sd card >>>> >>>> You will not get any UART output prior to the kernel boot, the GPU boot >>>> code does not output anything (at least not in the builds we use). >>>> >>>> Could you share the boot log to see if there is anything obvious? >>>> >>>>> >>>>> John >>>>> _______________________________________________ >>>>> openwrt-devel mailing list >>>>> [email protected] <mailto:[email protected]> >>>>> https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel >>>> >>>> >>>> >>>> _______________________________________________ >>>> openwrt-devel mailing list >>>> [email protected] >>>> https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel >>>> _______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
