Okay, it's working now: http://files.noltari.es/openwrt/bcm2708/bcm2708_3-18_log.txt
Patches: http://files.noltari.es/openwrt/bcm2708/brcm2708_3-18.tgz El 10/02/2015 a las 13:10, Álvaro Fernández Rojas escribió: > I could finally boot 3.18 by loading the rootfs from USB: > http://pastebin.com/b4dX0X7B > > Everything seems to be working fine, still no clue about the SD issues... > http://pastebin.com/G61ALvLX > > El 10/02/2015 a las 11:09, Álvaro Fernández Rojas escribió: >> The pins you said are the right ones. However, if anything fails before the >> kernel is booted you won't get any output. You could try booting a 3.14 >> image and check if you are properly connected to the uart. >> >> It may be some wrong configuration related to the recently added DT support, >> which expects a DTB and since no DTB is passed from the bootloader, the >> kernel crashes before any output. >> >>> El 10/2/2015, a las 6:29, John Crispin <[email protected]> escribió: >>> >>> ok, so uart, how do you connect it ? >>> >>>> On 10/02/2015 02:02, Álvaro Fernández Rojas wrote: >>>> I tried adding support for 3.18 and I have issues booting the raspberry. >>>> There must be something wrong with the new mmc driver, because it detects >>>> the SD card insertions/extractiones, but doesn't read the partitions: >>>> http://pastebin.com/GWFYrXnT >>>> >>>> My patches: >>>> http://files.noltari.es/openwrt/bcm2708/brcm2708_3-18.tgz >>>> >>>> Regards, >>>> Álvaro. >>>> >>>>> El 09/02/2015 a las 18:12, Florian Fainelli escribió: >>>>>> On Feb 9, 2015 4:25 AM, "John Crispin" <[email protected] >>>>>> <mailto:[email protected]>> wrote: >>>>>> >>>>>> Hi, >>>>>> >>>>>> i synced our rpi port with the upstream tree on github. it boots and i >>>>>> can see the coloured palette test pic on the hdmi, however ethernet >>>>>> fails to come up. i attached a uart just to find out that my rpi is >>>>>> either broken or i am connecting it wrong. >>>>>> >>>>>> has anyone managed to get uart working ? to my understanding i need to >>>>>> connect pin6 to gnd and use 8 and 10 for the 2 data lines. should i see >>>>>> output from the bootloader prior to board detecting/loading the sd card >>>>> >>>>> You will not get any UART output prior to the kernel boot, the GPU boot >>>>> code does not output anything (at least not in the builds we use). >>>>> >>>>> Could you share the boot log to see if there is anything obvious? >>>>> >>>>>> >>>>>> John >>>>>> _______________________________________________ >>>>>> openwrt-devel mailing list >>>>>> [email protected] <mailto:[email protected]> >>>>>> https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel >>>>> >>>>> >>>>> >>>>> _______________________________________________ >>>>> openwrt-devel mailing list >>>>> [email protected] >>>>> https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel >>>>> _______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
