#20409: uboot-lantiq: Arcadyan VGV7510KW22 brn-boot V1.08.01 does not work
--------------------------+----------------------------------
Reporter: cmoegele | Owner: developers
Type: defect | Status: new
Priority: normal | Milestone: Chaos Calmer (trunk)
Component: base system | Version: Trunk
Resolution: | Keywords:
--------------------------+----------------------------------
Comment (by cmoegele):
sorry for any inconvenience, but the message with mount error was already
in u-boot-nor on this device the brn-boot is not working any more. So now
I have half working nor-u-boot which is better than uart mode ;)
On the other device with brn-boot your pre-compiled binary shows still
following error message:
[VR9 Boot]:m
RAM upload destination: (default:0x80002000) : 0x
Starting XModem download...(press Enter to abort)
CCCCCCC
[VR9 Boot]:y
Go to Memory Address: (default:0x80002000) : 0x
Jump to address 0x
U-Boot 2014.01-openwrt4-g51ef7f2 (Sep 17 2015 - 21:39:56) VGV7510KW22
Board: Arcadyan VGV7510KW22
SoC: Lantiq VRX288 v1.2
CPU: 500 MHz
IO: 250 MHz
BUS: 250 MHz
BOOT: NOR
DRAM: 64 MiB
Flash: 16 MiB
Using default environment
In: serial
Out: serial
Err: serial
SPI: ready
Net: Phy not found
ltq-eth
Hit any key to stop autoboot: 2 1 0
## Booting kernel from Legacy Image at b0080000 ...
Image Name: MIPS OpenWrt Linux-3.18.21
Created: 2015-09-04 14:39:09 UTC
Image Type: MIPS Linux Kernel Image (lzma compressed)
Data Size: 1543521 Bytes = 1.5 MiB
Load Address: 80002000
Entry Point: 80002000
Verifying Checksum ... Bad Data CRC
ERROR: can't get kernel image!
VGV7510KW22 #
--
Ticket URL: <https://dev.openwrt.org/ticket/20409#comment:9>
OpenWrt <http://openwrt.org>
Opensource Wireless Router Technology
_______________________________________________
openwrt-tickets mailing list
[email protected]
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-tickets
