Paul, here is a link to the ATOTO web site that gives some dimensions for the unit: http://www.myatoto.com/index.php?m=content&c=index&a=show&catid=15&id=57
If your faceplate really is only 1.5U it probably won't work. You need a full 2DIN opening for this unit. My truck had a 2DIN faceplate but the internal (guts) of the unit was only 1DIN. I had to remove some sheetmetal under the dash to get this unit in. But I knew that ahead of time based on reports by others. The modification that I had to make does not cause any structural integrity issues and does not prevent reinstalling the old unit if I want to. In my 2014 RAM 2500 the display is perfectly positioned, it does not block the heat/AC vents and it does not interfere with my manual stick shift. The screen does not have a polarized filter so polarized sunglasses do not block the display (at least I have not had any issues with that). I also like that it has a physical volume knob. In fact, it was one of my "must have" requirements - I hate fiddling with on-screen controls when I need to quickly increase or decrease the volume. On Wednesday, October 2, 2019 at 10:01:02 PM UTC-4, Paul Johnson wrote: > > I'm a little curious about the clearances and fit, since my truck has a > bit of a lip to the dashboard right above the stereo and one of those fun > to work with 1.5U GM stereo bays. > >> >> -- You received this message because you are subscribed to the Google Groups "Osmand" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/osmand/f29782e1-f221-4293-a9ca-959a7da658f5%40googlegroups.com.
