Hi guyz,
I need some help here, i have done my initial packetfence configuration
defining the Management, Registration and Isolation Vlan. I have as well
configured snmp v2 on both the Packetfence and the Cisco 2960 switch. I have
defined the Mac-Detection vlan same as Isolation vlan. Its the vlan i have
configured on the user interface of the switch as shown below;
Registration Vlan= Vlan 10
Isolation Vlan = Vlan 20
Mac-Detection Vlan = Vlan 20
interface GigabitEthernet0/3
switchport access vlan 20
switchport mode access
switchport port-security maximum 1 vlan access
switchport port-security
switchport port-security violation restrict
switchport port-security mac-address 0025.1185.e79f
spanning-tree portfast
end
ECS-ASW-FL1#sh run | i snmp
snmp-server community Pass123 RW 15
snmp-server enable traps port-security
snmp-server enable traps port-security trap-rate 1
snmp-server host 10.10.0.10 version 2c Pass123 port-security
snmp-server manager
ECS-ASW-FL1#sh run | i access-l
access-list 15 permit 10.10.0.10 log
When i start the user computer i am redirected to the login page and issued ip
on vlan 20 via dhcp. However when i input my credetials i get the error wrong
username/password.
When i manually set the computer as registered, i am redirected to a page that
states 'you network should be enabled within a minute or two...' and nothing
happens even after reboot.
snmpwalk works but running snmptrapd.log nothing is displayed
What or where would i be going wrong? Help me out here brilliants!
Regards,
Frank
------------------------------------------------------------------------------
This SF.net email is sponsored by Windows:
Build for Windows Store.
http://p.sf.net/sfu/windows-dev2dev
_______________________________________________
PacketFence-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/packetfence-users
