Thanks. I often have to move the wires around, which is why I thought a new wire might solve the trick. However, I can't get a completely non-existent buzz without holding the middle of it up in the air, which obviously isn't feasible. I just find it odd that it does it with the digital radio but not with the iPhone, as they're both digital appliances and I don't move the wire when swapping over devices (obviously I have to take the jack out of one and put it in the other but the cable itself stays flat rather than up in the air while attached to the iPhone and it remains in the same position). Is it possible that the iPhone is simply better designed for this sort of thing than both of my other devices and, although I appreciate that it's probably quite technical, I'd be grateful for any info on how to identify suitable equipment for the future if that's the case.
Danny On 8/29/17, Smiling? <bli...@sbcglobal.net> wrote: > If you seem to not get this buzz as you put it when you are recording > whatever from your iPhone, it must be something specifically with either the > digital radio or some routing of the cables involved. Try moving the cables > around and see what comes of it because sometimes certain cables crossing > paths can cause noise depending on the quality of the shielding or lack > thereof. > > -----Original Message----- > From: Pc-audio [mailto:pc-audio-boun...@pc-audio.org] On Behalf Of Danny > Miles > Sent: Tuesday, August 29, 2017 05:19 AM > To: PC Audio Discussion List > Subject: Issue with Buzz in Radio Recordings > > Hi. For a long time now, I have noticed that I get buzzing in > recordings from my digital radio and tape recorder, even though using > the same set-up (2x RCA phono connectors in my mixer to 1x 3.5 mm jack > in the audio device in question) works perfectly when using my iPhone > to record. I'm using GoldWave 5.65 (I know it's not the latest > version) and, although I've tried all of the hiss/hum removal options, > I can't seem to get rid of all of it. The best result that I got was > when I used Stereo Center to keep just the channel with the least > (almost hardly any) buzz and then put that channel into a mono mix. > However, it still didn't remove the whole hiss and, of course, it lost > a lot of the bass as a result of removing the other channel. I've > also tried buying a brand new lead but I'm still getting the same > results (at least, I've trialled it with the digital radio and am > still getting a lot of buzz, which I knew was going to happen as soon > as I plugged it in because I could hear it in my headphones via the > mixer). > > So, does anybody please know why this might be happening with two > devices but not with my phone, even though the radio is digital (so > it's not a matter of using a mono device)? Also, does anyone know of > settings/processes that I can run with GoldWave or another piece of > software to successfully remove everything, or am I just going to have > to accept things as they are? > > Many thanks in advance for any help, Danny > > >
