The upgrade shouldn't be a problem. Did you use the card to transfer
the files? Did everything work okay at that time? My first *istD
wouldn't recognize any cards out of the box. I had to return it.
Haven't had any problems since. Try another card to see if the camera
is at fault. If you only have one, you're eventually going to need a
second card anyway. You can pick up a half gig card for less than fifty
US over here, so it shouldn't be too costly. If you have the same
problem with a second card, return the camera. The vendor should be
willing to replace it, since it's new. I had no problems with B&H.
Paul
On Jun 4, 2005, at 7:39 AM, Thibouille wrote:
Doesn't work.
It reads and formats without problem under WinXP.
Then put it into the camera. Tells me it is not formated and refuse to
format it itself.
Weird.
I should note I immediately did the upgrade to 1.12 firmware. Would it
be a source of problem ?
2005/6/4, Frantisek <[EMAIL PROTECTED]>:
Which card?
Does it read on PC?
Try formatting it on the PC (as FAT16 if it's <=2GB card, as FAT32 if
it's 2GB+ card! Not NTFS or Mac or whatever).
If it works:
Then, use some software that scans the "surface" for read/write
errors.
Then, format it in the camera again.
Hope this helps...
Good light!
fra
--
----------------------
Thibouille
----------------------
*ist-D,Z1,SuperA,KX,MX and KR-10x ...
