From: Rob Studdert
On 13 February 2011 05:28, John Sessoms <[email protected]> wrote:
> It gives dimensions for everything in decimal fractions of an inch, but
> there's a conversion table in the interface.
Why I love the SI metric system.
Metric is fine as long as I don't need to convert it into miles, feet &
inches. I'm just as happy to measure in mm, cm, m & km; but only if the
necessary output has to be metric. If I've got to convert it, I'd rather
have a program that works in whatever unit the final output needs to be in.
The scale on the mat cutter is marked off in 1/16 inch increments. I
want the output to be in 1/16 inch increments.
Metric would just add another layer of conversion factors I'd have to
multiply by.
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1204 / Virus Database: 1435/3440 - Release Date: 02/12/11
--
PDML Pentax-Discuss Mail List
[email protected]
http://pdml.net/mailman/listinfo/pdml_pdml.net
to UNSUBSCRIBE from the PDML, please visit the link directly above and follow
the directions.
