Hey Guys, I ran into a rather disconcerting problem this morning (just before we sent this board for fabrication). I found a part in this particular PCB that had an 0603 geometry where there should have been a 1206. The really disconcerting part is that the "footprint" field for this part said 1206 (which is correct). I could have explained this as human error if it was the only part. However, further review turned up an 0603 geometry where an 0805 should have been. I'm still looking for other problems.
1) Anybody seen anything like this before? or can come up with an sequence of steps that may have caused this? 2) Its going to take a long time to check every part in the design. Anybody have any suggestions for finding further errors? Darcy ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
