On Thu, 24 Feb 2005 14:41:10 -0700, Dan Enslen <[EMAIL PROTECTED]> wrote:
Gentlepeople,
I've got a problem with a polygon pour that I can't seem to solve. I
have to modify an existing PCB footprint (new mounting holes are larger)
which then errors on the polygon. I try to redraw the polygon and the darn
thing won't fill in completely.
Can you redraw it as 2 (or more) smaller polygons?
(I've been down this route - if I ran with teardropped pads (drawn with arcs), I could only draw relatively small polygons)
Not seen this since abandoning for DXP, but it was very frustrating at the time.
Steve
____________________________________________________________ You are subscribed to the PEDA discussion forum
To Post messages: mailto:[email protected]
Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
