Dan,
I believe that I have seen a very similar occurrence just in the last
few days. In my case I had the move a couple of the polygon vertices just a few
mils in order to get the unfilled polygon area to fill. Use 'M' 'G' (move
polygon vertice) and just shift the vertices in the offending areas slightly (5
- 10 mils maybe) and allow it to repour.
It seems the poylgon pour routine has problems with some of the
mathematics under some limited circumstances.
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
1925 Kirschner Rd.,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2329 ext. 225
fax (250) 762-3374
-----Original Message-----
From: Dan Enslen [mailto:[EMAIL PROTECTED]
Sent: Thursday, February 24, 2005 1:41 PM
To: [email protected]
Subject: [PEDA] Protel 99se Polygon Pour Problem
Gentlepeople,
I've got a problem with a polygon pour that I can't seem to solve. I
have to modify an existing PCB footprint (new mounting holes are larger)
which then errors on the polygon. I try to redraw the polygon and the darn
thing won't fill in completely. It also seems to partially draw over
existing copper (sort of runs up to an existing trace ) even though I don't
have the checkbox set. This seems to be with this ddb only and I have tried
to repair it to no avail. Copying the pcb didn't help either. Any
suggestions? Thanks.
Dan Enslen
Texas Instruments Tucson
520.746.7324
[EMAIL PROTECTED]
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
