steve might be onto something re this
i can't think of anything else
have you looked at design rules poly connect style ?
i assume you have pour over same net turned on in polyg pour dialog
my min primitive size is 3mils, doubt that that is the issue
ds
_______________________________________________________________________ Integrated Controls, Inc. Tel: 415-647-0480 EXT 107 2851 21st Street Fax: 415-647-3003 San Francisco, CA 94110 www.integratedcontrolsinc.com
Nukien wrote:
Weird. Not working here.
I have polygons on top and bottom layers, both on GND net. I drop a via on a blank spot, and it picks up the GND net just fine. I can verify that in the properties for the via.
I then redo the polygons, they rebuild, but the via is isolated. But it still has the GND net associated with it, and there's a rats-nest line leading to the nearest pad on the GND net. If I select the via, the whole GND net is highlighted as you would expect. Even weirder, DRC doesn't flag a Broken Net error ...
The polygons have correctly attached to all the GND pads on the various components, just not the via. The polys are definitely good - they're providing connectivity all over the place for GND.
Dropping round pads with the same dimensions works fine.
What the <bleep> ?
PS - what's the "Minimum primitive size - Length" box for in the polygon properties dialog ? I've never messed with it - I think it's always set to 2mil.
____________________________________________________________ You are subscribed to the PEDA discussion forum
To Post messages: mailto:[email protected]
Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
