> -----Original Message----- > From: J. Mark Wolf [mailto:[EMAIL PROTECTED] > Sent: 13 May 2005 12:25 > To: Protel EDA Discussion List > Subject: RE: [PEDA] Database translation > > My PowerPCB is version 5.2, and the ascii files I export > indicate they are version 5.0. I don't have any additional > "save" and "export" options.
Yes they are there. File, Export, Give the file a name, click Save and only then will you have your export options, Under format drop down to PowerPCB V3.0, set units, select etc...... Then hit OK If you want to save time at import remove all layers that are not needed before saving. John > > Brad Velander <[EMAIL PROTECTED]> wrote:Mark, For the PADs > PowerPCB files, you save them from PADs in 3.5 format Ascii. > They will then import into DXP 2002 SP2 or higher, quite well. > Sorry the rest I can't help you on. > > Sincerely, > Brad Velander > Senior PCB Designer > Northern Airborne Technology > 1925 Kirschner Rd., > Kelowna, BC, V1Y 4N7. > tel (250) 763-2329 ext. 225 > fax (250) 762-3374 > > > -----Original Message----- > From: J. Mark Wolf [mailto:[EMAIL PROTECTED] > Sent: May 12, 2005 1:49 PM > To: [email protected] > Subject: [SPAM] - [PEDA] Database translation - Email found in subject > > > I need to translate a few Mentor schematics (Viewlogic) and > PADS PowerPCB PCB files to Protel 2004. Can anyone on the > forum suggest an economical means of doing so? > > I have access to both the Mentor and PowerPCB software, but > any files, even the Pads ascii files I export from them are > not recognizable by Protel 2004 > > > "May a suitable landing spot be always on your glide slope" > J. Mark Wolf, Pinckney, Michigan > Rotorway Exec162F N1955Z > Check out my web site at: www.rotorwaybuilders.net/ucosm > > > > ____________________________________________________________ > You are subscribed to the PEDA discussion forum > > To Post messages: > mailto:[email protected] > > Unsubscribe and Other Options: > http://techservinc.com/mailman/listinfo/peda_techservinc.com > > Browse or Search Old Archives (2001-2004): > http://www.mail-archive.com/[email protected] > > Browse or Search Current Archives (2004-Current): > http://www.mail-archive.com/[email protected] > > > > > "May a suitable landing spot be always on your glide slope" > J. Mark Wolf, Pinckney, Michigan > Rotorway Exec162F N1955Z > Check out my web site at: www.rotorwaybuilders.net/ucosm > > ____________________________________________________________ > You are subscribed to the PEDA discussion forum > > To Post messages: > mailto:[email protected] > > Unsubscribe and Other Options: > http://techservinc.com/mailman/listinfo/peda_techservinc.com > > Browse or Search Old Archives (2001-2004): > http://www.mail-archive.com/[email protected] > > Browse or Search Current Archives (2004-Current): > http://www.mail-archive.com/[email protected] > > > ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
