Thanks, I'll try that! On May 1, 2016 15:31, "Tadeusz Sośnierz" <tadeusz.sosni...@onet.pl> wrote:
> To expand on why putting the file in a directory doesn't Just Work, and > why so much magic needs to be there for it to work: loading modules is a > complicated thing in Perl 6, and long story short, if you want to be able > to have multiple versions installed and loadable at the same time, you need > some magic under the hood to compensate for that. This magic is what makes > installing/precompiling a module you want to have installed more > complicated than a couple of 'mv's. > > If you want to avoid the overhead of panda or other installers (to their > defense, there are several good reasons why they're so bulky and > complicated :)), I sometimes use a script based on Module::Toolkit, where > if you want to "just install the damned thing, nothing else", it's just a > simple 'mtk install .': > https://gist.github.com/tadzik/dc5c12cab0dc141167fb850f9ede2117 > > Hope this helps, > > tadzik > On 01/05/16 15:23, Brock Wilcox wrote: > > I recommend putting your module into a 'lib' dir near your script. Then in > your script add: > > use lib 'lib'; > > That way you don't have to add the -l param. > On May 1, 2016 09:21, "Fernando Santagata" <nando.santag...@gmail.com> > wrote: > >> Hello, >> >> I'm trying to write a module and make a program load and use it. >> Since this code: >> >> perl6 -e 'say $*REPO' >> >> outputs: >> >> inst#/home/nando/.perl6 >> >> I thought that putting the .pm6 file in there would be enough. So, since >> my module is A::B, I put B.pm6 into ~/.perl6/A . >> But when I run a test program which loads A::B, I receive this error: >> >> ===SORRY!=== >> Could not find A::B at line 5 in: >> /home/nando/.perl6 >> /home/nando/.rakudobrew/moar-2016.04/install/share/perl6/site >> /home/nando/.rakudobrew/moar-2016.04/install/share/perl6/vendor >> /home/nando/.rakudobrew/moar-2016.04/install/share/perl6 >> CompUnit::Repository::AbsolutePath<140256602878904> >> CompUnit::Repository::NQP<140256602876152> >> CompUnit::Repository::Perl5<140256602873560> >> >> If I run the test program this way it works: >> >> perl6 -I ~/.perl6 ./test.p6 >> >> Why is that? Where should I put the module file to be seen automatically, >> without adding the -I option? >> >> As a side note, if I want to precompile the module, as panda does when >> installing new modules from the repository, where should I put the .moarvm >> file? >> >> Thanks! >> >> -- >> Fernando Santagata >> > >