On Tue, 02 Nov 2004 06:47:53 +0530, Agtech Systems <[EMAIL PROTECTED]> wrote: > Hello, > > Now my prob is that I cannot configure this modem to be used in kppp as > the device is not listed in the Modem section. I refered to Redhat site > and found out that if an internal modem gets detected correctly it will > work and that it will be configured as /dev/modem. Upon selecting that > as a device I am unable to dial. It says Unable to open modem.
Have a look at KPPP. You can change the default modem device. > > The wvdial util does dial the number but I have a pulse line and not a > tone . By default the modem must have been configured to ATDT and not > ATDP. I also gave the prameteres in the wvdial.conf as below AFAIK, tone dialing is supported by all BSNL lines in India. Pune for sure. All exchanges in Pune support tone dialing. BTW, can I ask how did you confirm that your telephone line doesn't support tone dialing? > > [Dial Pulse] > Dial Command = ATDP > > but still the modem dials ATDT ... and the telephone no. Since it will > not get the dial tone it says line busy. Is there any way to set the > modem dialing to ATDP ? Or best is any way I can run this in kppp ? Can you show complete wvdial.conf? The one which you are using. *Remove username and password and other personal data.* Regards, Shantanoo -- ______________________________________________________________________ Pune GNU/Linux Users Group Mailing List: ([EMAIL PROTECTED]) List Information: http://plug.org.in/mailing-list/listinfo/plug-mail Send 'help' to [EMAIL PROTECTED] for mailing instructions.
