d6jg wrote: > Phillipe > I am now using the Dev but am still seeing some "issues". The Onkyo does > not have network standby (although the manual says it should, Onkyo > support say this model doesn't) so when I have finished work I put the > Onkyo into power standby mode i.e. switch it off as far as the network > is concerned. From the logs I can see that 10 minutes or so later sq2u > stops for no apparent reason. I then have to switch it on again in the > morning. That isn't the intention is it ? > > Log extract. > > [17:16:33.002584] UpdateMRThread:851 Begin uPnP devices update > [17:16:33.229124] UpdateMRThread:931 [0x80e9f00]: removing renderer > (CR-N755) > [17:16:33.229191] slimproto_close:1019 [0x8091b40] slimproto stop for > CR-N755 > [17:16:33.229240] output_mr_close:817 [0x8091b40] close media renderer > [17:16:33.301019] decode_close:180 close decode > Then empty until I switch on again in the morning > >
No in fact you should see, with the debug level you've selected, every 30 seconds a set of lines ======== Begin uPnP devices update End uPnP devices update XXXX ======== When you switch back on the Onkyo, it should take up to 30s to be discovered again. On my own network, I have a device that disapear every 5-10 minutes and that allows me to test this insertion / removal. Do you know if the process was still running of was it stopped ? LMS 7.7.2 - 5 radio, 3 Boom, 4 Duet, 1 Touch, 1 SB2. Sonos 2xPLAY:1, PLAY:3, PLAY:5, Marantz NR1603, JBL OnBeat, XBMC, Foobar2000, XBoxOne (sort of) ------------------------------------------------------------------------ philippe_44's Profile: http://forums.slimdevices.com/member.php?userid=17261 View this thread: http://forums.slimdevices.com/showthread.php?t=103728 _______________________________________________ plugins mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/plugins
