> > I currently have my PowerPro bar at the top of my screen, full size. > Most of the time I've had the '3d frame' option under the config > checked. This was because if I didn't, the icons on the bar itself > had a little bit of their tops cut off. However, I have turned that > option off now, as when it is on, you can hold your mouse over the > edge of the bar and drag to size it. I was resizing it down to 0 > pixels accidentally too often, so I had to switch the option off. > Now however, I have the tops of the icons cut off.
Some things things to try (try any one of these by itself): 1. Width 3d option off, change height of buttons with command list|properties|height. 2. With 3d option on, after positioning bar, change position to "locked" and use Desktop setworkarea to reserve top of screen for bar (make it a startup scheduled event). 3. With 3d option on, and bar across whole top of screen, change bar size to full screen (current size). Set vertical offset to about -4 to get rid of any gap between bar and working area of screen, if desired. ------------------------ Yahoo! Groups Sponsor --------------------~--> Get fast access to your favorite Yahoo! Groups. Make Yahoo! your home page http://us.click.yahoo.com/dpRU5A/wUILAA/yQLSAA/JV_rlB/TM --------------------------------------------------------------------~-> Attention: PowerPro's Web site has moved: http://www.ppro.org Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/power-pro/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
