Sorry To Ask Again, but I still cannot get a "Chime" or Video at
Startup!
Re seated all boards (daughterboard, ram, CPU, everything.
Replaced Battery.
Installed Segate Barracuda ST19171WC 9.1 MB HD and 50 to 80 pin adapter
Connected to
SCSI Connector on Motherboard. It starts running when power
applied.
Installed Sony CDU415 CD Rom, connected to PCI SCSI Board on Daughter
Board.
Pressed CUDA over and over.
Still no chime. SVGA PC monitor jack tried, Mac Monitor tried, even two
monitors connected
at once, and still no video or chime.
Any suggestions what to try next?
Perhaps something bad on the motherboard? It was working when I had a 9
gig external SCSI
on it. Surely someone else on this list has had the same problem!
Thank You, James Gribble, Rogers Arkansas
--
Power Computing is sponsored by <http://lowendmac.com/> and...
123Inkjets.com <http://lowendmac.com/ad/123inkjets.html>
Support Low End Mac <http://lowendmac.com/lists/support.html>
Power Computing list info: <http://lowendmac.com/power/list.html>
--> AOL users, remove "mailto:";
Send list messages to: <mailto:powercomputing@;mail.maclaunch.com>
To unsubscribe, email: <mailto:powercomputing-off@;mail.maclaunch.com>
For digest mode, email: <mailto:powercomputing-digest@;mail.maclaunch.com>
Subscription questions: <mailto:listmom@;lemlists.com>
List archive:
<http://www.mail-archive.com/powercomputing%40mail.maclaunch.com/>
---------------------------------------------------------------
>The Think Different Store
http://www.ThinkDifferentStore.com
---------------------------------------------------------------
