Bryan Bernesi wrote:
> I have 24 isolated -6V nets that I would like to pass on the power plane,
> and 24 isolated GND that i would like to pass on the GND plane. my question
> is, can I use the power plane as a regular internal plane? i.e. passing
> traces on the plane layers?
I see two ways to go:
1) use a regular internal layer for the 24 isolated nets and then use
fills and/or polygons for any required "plane" areas.
2) draw 24 split planes on a plane layer.
David W. Gulley
Destiny Designs
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* This message sent by: PROTEL EDA USERS MAILING LIST
*
* Use the "reply" command in your email program to
* respond to this message.
*
* To unsubscribe from this mailing list use the form at
* the Association web site. You will need to give the same
* email address you originally used to subscribe (do not
* give an alias unless it was used to subscribe).
*
* Visit http://www.techservinc.com/protelusers/subscrib.html
* to unsubscribe or to subscribe a new email address.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
________________________________________________________
To leave the EDAFORUM discussion list, send a email with
'leave edaforum' in the body to '[EMAIL PROTECTED]'
More Information : http://www.dolist.net
