Hello Steve,
Thank you for the info, but I guess I didn't phrase my question properly.
I have 24 isolated -6V nets that I would like to pass on the power plane,
and 24 isolated GND that i would like to pass on the GND plane. my question
is, can I use the power plane as a regular internal plane? i.e. passing
traces on the plane layers?
Bryan Bernesi
"The Rookie"
----- Original Message -----
From: "Steve Smith" <[EMAIL PROTECTED]>
To: "Multiple recipients of list proteledausers"
<[EMAIL PROTECTED]>
Sent: Wednesday, February 14, 2001 5:01 PM
Subject: RE: [PROTEL EDA USERS]: ASSIGNING NETS TO A POWER PLANE
> Hi Bryan,
> Go to Design/Layer Stack Manager and select the plane you wish to assign
> your primary (most used)
> ground to. Select Properties and at Net name assign the ground net.
Repeat
> for your power plane.
> Then go to Design/Split Planes. Select Add and assign the Track width to
> separate the plane, the
> layer (plane) you are splitting, and the ground/power net you are
assigning
> to this plane and then
> place the tracks around the appropriate pins.
>
> Steve Smith
> Product Engineer
>
> Staco Energy Products Co.
> Web Site: www.stacoenergy.com
>
>
> >-----Original Message-----
> >From: Bryan Bernesi [mailto:[EMAIL PROTECTED]]
> >Sent: Wednesday, February 14, 2001 9:58 AM
> >To: Multiple recipients of list proteledausers
> >Subject: [PROTEL EDA USERS]: ASSIGNING NETS TO A POWER PLANE
>
>
> >Hello,
>
> >Please forgive my inexperience, but how would I assign all of my isolated
> power and ground nets to the inner
> >power-planes?
>
> >Bryan Bernesi
>
>
>
>
> * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
> * This message sent by: PROTEL EDA USERS MAILING LIST
> *
> * Use the "reply" command in your email program to
> * respond to this message.
> *
> * To unsubscribe from this mailing list use the form at
> * the Association web site. You will need to give the same
> * email address you originally used to subscribe (do not
> * give an alias unless it was used to subscribe).
> *
> * Visit http://www.techservinc.com/protelusers/subscrib.html
> * to unsubscribe or to subscribe a new email address.
> * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* This message sent by: PROTEL EDA USERS MAILING LIST
*
* Use the "reply" command in your email program to
* respond to this message.
*
* To unsubscribe from this mailing list use the form at
* the Association web site. You will need to give the same
* email address you originally used to subscribe (do not
* give an alias unless it was used to subscribe).
*
* Visit http://www.techservinc.com/protelusers/subscrib.html
* to unsubscribe or to subscribe a new email address.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
________________________________________________________
To leave the EDAFORUM discussion list, send a email with
'leave edaforum' in the body to '[EMAIL PROTECTED]'
More Information : http://www.dolist.net
