Interestingly,
Although the design rules now show the correct diagram for annular
ring (pad radius - hole radius) and the design rules interpret the rule
correctly; however, the board report still shows annular rings
calculated as pad diameter - hole diameter. (This is 99SE-SP5.)
This is not a major problem, except a customer wanted to know why I
was being so generous with the annular rings on the board when he saw
the report!
David W. Gulley
Destiny Designs
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* This message sent by: PROTEL EDA USERS MAILING LIST
*
* Use the "reply" command in your email program to
* respond to this message.
*
* To unsubscribe from this mailing list use the form at
* the Association web site. You will need to give the same
* email address you originally used to subscribe (do not
* give an alias unless it was used to subscribe).
*
* Visit http://www.techservinc.com/protelusers/subscrib.html
* to unsubscribe or to subscribe a new email address.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
________________________________________________________
To leave the EDAFORUM discussion list, send a email with
'leave edaforum' in the body to '[EMAIL PROTECTED]'
More Information : http://www.dolist.net
