>
> Edit footprint name? I think this is the issue - you need to put the new
> footprint in the relevant Copy Attribute edit box. Changing the footprint
> edit list does not work. This is different to PCB where the changes are
> made "in-place".
>
Thanks Ian
I do now recall something similar happening with the part type attribute a
while back.
Yes, a little consistency would nice.
Regards
Mick Beavis
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* This message sent by: PROTEL EDA USERS MAILING LIST
*
* Use the "reply" command in your email program to
* respond to this message.
*
* To unsubscribe from this mailing list use the form at
* the Association web site. You will need to give the same
* email address you originally used to subscribe (do not
* give an alias unless it was used to subscribe).
*
* Visit http://www.techservinc.com/protelusers/subscrib.html
* to unsubscribe or to subscribe a new email address.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
________________________________________________________
To leave the EDAFORUM discussion list, send a email with
'leave edaforum' in the body to '[EMAIL PROTECTED]'
More Information : http://www.dolist.net
