I think we heard this about SP6
does the .DRR file look correct?
I think maybe it's "just" the gerber plots

Dennis Saputelli


"Brooks,Bill" wrote:
> 
> I just installed the SP6 on our Protel 99SE software a week ago... We use
> the "size of hole" string as the code for the hole location on our drill
> drawings. Up until now we have had no problems with this... Today I
> discovered a bug. I was getting ready to send out a board and looked at the
> drill table or Hole Chart if you will, and noticed that the codes for the
> holes were scrambled.. They look like they are right on the board but the
> chart is messed up. Here's what I got...
> --------------------------------------------------------------------
> 125     45      14mil   0.3556mm        PTH
> 32      6       32mil   0.8128mm        PTH
> 55      12      35mil   0.889mm PTH
> 35      27      40mil   1.016mm PTH
> 14      8       55mil   1.397mm PTH
> 40      6       125mil  3.175mm PTH
>         104     Total
> --------------------------------------------------------------------
>         HOLE CHART
> 
> Here's what's in the Drill report
> 
> ---------------------------------------------------------------------------
> NCDrill File Report For: 738481q3.pcb   23-Feb-2001  11:57:15
> ---------------------------------------------------------------------------
> 
> Layer Pair : TopLayer to BottomLayer
> ASCII File : NCDrillOutput.TXT
> EIA File   : NCDrillOutput.DRL
> 
> Tool         Hole Size          Hole Count Plated       Tool Travel
> ---------------------------------------------------------------------------
> T1        14mil (0.3556mm)         45               14.76 Inch (374.88 mm)
> T2        32mil (0.8128mm)         6                6.86 Inch (174.37 mm)
> T3        35mil (0.889mm)          12               5.29 Inch (134.48 mm)
> T4        40mil (1.016mm)          27               11.14 Inch (282.85 mm)
> T5        55mil (1.397mm)          8                10.79 Inch (274.04 mm)
> T6        125mil (3.175mm)         6                21.52 Inch (546.63 mm)
> ---------------------------------------------------------------------------
> Totals                             104              70.36 Inch (1787.25 mm)
> 
> Total Processing Time : 00:00:03
> 
> ----------------------------------------------------------------------------
-- 
___________________________________________________________________________
www.integratedcontrolsinc.com            Integrated Controls, Inc.    
   tel: 415-647-0480                        2851 21st Street          
      fax: 415-647-3003                        San Francisco, CA 94110

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
*  This message sent by: PROTEL EDA USERS MAILING LIST
*
*  Use the "reply" command in your email program to
*  respond to this message.
*
*  To unsubscribe from this mailing list use the form at
*  the Association web site. You will need to give the same
*  email address you originally used to subscribe (do not
*  give an alias unless it was used to subscribe).
*
*  Visit http://www.techservinc.com/protelusers/subscrib.html
*  to unsubscribe or to subscribe a new email address.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

________________________________________________________
To leave the EDAFORUM discussion list, send a email with
'leave edaforum' in the body to '[EMAIL PROTECTED]'

Reply via email to