Hi all,
I have a project with 3 small (about 8 sq inch) PCBS.
A set of PCBS for a unit consists of 2 of one type and one each of the
others.
Volume is low and my board house makes fixed charges for plotting and
screen set ups which represents a fair part of the cost for say a batch of
10 sets.
One of the PCBS really needs to be 4 layers, 4 layers would be nice on the
others.
I am thinking of making a panel with a set of 4 PCBS on it whch to the
board house looks like one plot/screen charge and a bit of extra routing.
Any thoughts on the best way to do this?
I am a bit worried about just copying into a new PCB file. There is
obviously no valid netlsit for the set and I am worried about plane
connections which are automatically derived from the netlist - is there a
danger these will be lost or screwed up? I don't need annotations so
component renaming is probably not an issue.
At the moment I am thinking of merging gerbers with Camtastic but not sure
what problems I will run into.
Any advice?
Cheers, Terry.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *